SB-3 Pool Ladder Surface-Mount Base

Saftron 3" Surface-Mount Bases for Pool Ladders - Mod. SB-3 To surface mount Swimming Pool Ladders to concrete or wood decks. Mounting hardware included. (3" H x 5.2" Diam). - An easier and less expensive installation alternative to Anchor Sockets for mounting pool ladders.  

*** As low as $23.15 and FREE FREIGHT to all contiguous USA destinations ***

* Maintenance-Free * 5 Colors * Non-Corroding * 5-Year Factory Warranty * 

Surface-mount bases enable fast and easy installation of swimming pool ladders to concrete or wood decks with minimal damage to mounting surface. As Saftron ladders meet all pool building codes without a need for grounding, they can be installed with surface-mount bases in any location that provides a secure anchoring foundation. Only four 5/16" holes need to be drilled to secure each base.

Bases are maintenance-free, unaffected by pool chemicals (chlorine, acid, salt) and available in the same 5 colors as Saftron's rails and ladders to give your patio a color-coordinated finish.

Product Features:

• Mounting hardware included (Four SS Lag Bolts, Washers and anchors)
• Color is an integral part of the material and not an after-coat. (The finish will never chip or flake).
• Non metallic material does not get hot in the sun.
• Immune to the corrosive effects of Salt Water Chlorinator Systems.
• Maintenance-Free Material and Finish.
• Made in *U*S*A*
• 5 Year Non Pro-Rated Manufacturer Warranty.

Available Colors: White, Beige, Taupe, Gray & Black

Dimensions:

• 3" Tall x 5.2" diameter at base.

Installation:

Use base to mark desired location and drill four 5/16" holes. Insert anchors and washers then install lag bolts. Slide ladder posts into base and tighten set-screws in base. For permanent installations PVC adhesive can also be used.

Notes: 

- Use of surface-mount bases will yield an installed rail height 4" taller than ladders grouted into the deck or installed with Anchor Sockets. Measurements indicated on drawings on this site assume the traditional in-ground installation of ladders.

- Escutcheons are not used when ladders are installed with surface-mount bases.

- 6" Bases (SB-F) used to mount pool rails can also be used for pool ladders, but the 3" base provides sufficient support as there minimal side-loads are exerted on pool ladders.