SAFTRON SSF-48 & SSF-59 SPA RAILS

Instructions   to install SSF series of Spa Rails to above-ground SPAS:
Notes:
  • SSF   Series Spa Rails attach to ground and to side of SPA
  • Install   with common household tools.
  • Suitable   for most above-ground SPAS.
CAUTION: VERIFY WITH SPA MANUFACTURER THAT SPACE   BEHIND SELECTED MOUNTING LOCATION IS CLEAR OF INTERNAL COMPONENTS AND WIRING.
Tools &   Materials Required:

INCLUDED ITEMS:
  • ONE   SSF-48 or SSF-59 Spa Rail
  • ONE   Slip-T Fitting Assembly
  • ONE   “End-cap” socket
  • ONE   2” x ¼” Bolt
  • ONE   ¼” Fender Washer
  • ONE   Staptoggle® ¼”-20 Hollow Wall Anchor
  • ONE   Single-Use tube of Adhesive
  • ONE   SB-6 6” Floor Base without set-screws
  • ONE   Floor Base Rectangular Insert
  • THREE   5/16” x 2” Lag Bolts
  • THREE   5/16” Washers
  • THREE   5/16” Alligator® Anchors

TOOLS REQUIRED:
  • Tape   Measure & Markers.
  • 1/2”   & 7/16” Socket Wrench
  • Rubber   Mallet
  • Battery   Powered Drill
  • DO NOT USE MAINS-POWERED TOOLS NEAR   WATER
  • ½”   Drill Bit
  • Soft   Scrub®

Installation   Steps:
 

WARNING: Before installing, verify with Spa   Manufacturer that space behind selected mounting location for Slip-T Fitting   is clear of internal components or wiring, and that Spa wall is strong enough   to support spa rail!

CAUTION:    Never use electric drills in or around   water

  1. Slide Slip-T support fitting onto rail and place rail in SB-6 Base.
  2. Hold rail assembly in desired location and mark hole locations for base and for Slip-T Support.
  3. Attach SB-6 base to floor as per SB-6   Mounting Instructions
  4. Use ½” bit to drill hole at location on spa marked for Slip-T.
  5. Insert Snaptoggle® Wall Anchor by holding metal channel flat alongside plastic   straps and sliding through ½” hole.
  6. Pull ends of Snaptoggle® Wall Anchor straps toward you until channel rests against   Spa wall.
  7. Slide plastic cap along straps until flange of cap rests against wall.
  8. Snap off straps.
  9. Place end cap socket over flange, and secure using fender washer and ¼” bolt with   7/16” socket wrench.
  10. Make sure End-Cap Socket and Slip-T Assembly are properly aligned, and both   surfaces are clean and dry.
  11. Apply adhesive to inside wall of end cap only. 
  12. Tap Slip-T assembly into End-Cap Socket with rubber mallet.
  13. Rails can be cleaned and polished using a soft rag and household Soft Scrub®.  
DO NOT USE ABRASIVES OR COMMERCIAL SOLVENTS.

Work quickly!   aDHESIVE starts to set in 20 seconds.Do not spill ADHESIVE on railing surfaces. Avoid contact with   skin. 
  
Wait AT LEAST  30 minutes before using.

NOTE:  The Slip-T   Assembly is designed to provide horizontal support to Spa Rail when inserted   into SB-F 6” base ONLY.  Pulling on rail if not fully inserted may cause   damage TO the Slip-T, or to the side of the spa.